JLSE
1
- Joined
- Dec 13, 2007
- Messages
- 3,580
- Points
- 0
SOLD
As im slowly getting away from the made in China hosts, here is my first
scratch built host with some new features.
This is a 3 mode 1.3W 445 with LED indicator, key switch and accidental
startup protection..
Should the operator forget to power down the laser and leave the clicky
in the 'on' position, shutting it off by the key only, when the key is turned to
'on' the laser will emit a brief flash but not fully power up. I am uploading
a video which will illustrate this property further..
The LD is mounted in a custom 2 piece copper mount. The focus assembly
also acts as an additional heatsink with deep fins.
Driver is a 3 mode featuring low, strobe and high.. There is no memory with this
and the laser starts in high. A brief interruption of power allows selection to low
power and the other modes by a slight tap on the clicky while in the 'on' position.
Battery used is 1 x 18650 unprotected (not included) though I am including
a new pair of goggles..
All thermal connections are made with plenty of acrtic silver paste and bonded
areas with arctic silver epoxy.
When the focus is set to a parallel beam, the focus ring sits tight against the
copper.. There is nothing lose fitting on this laser..
Asking 399. CDN shipped within North America with tracking. International
buyers are welcome, but will be required to pay for FedEx shipping as there is
no tracking available via Canada Post to overseas locations.
Warranty covers everything included and is good for 2 years from the purchase date..
Here are some pics, and video.
*EDIT* Low power pulsed is 200mW Med. power / strobe is 500mW
and high no pulse (CW) is 1.3W.
As im slowly getting away from the made in China hosts, here is my first
scratch built host with some new features.
This is a 3 mode 1.3W 445 with LED indicator, key switch and accidental
startup protection..
Should the operator forget to power down the laser and leave the clicky
in the 'on' position, shutting it off by the key only, when the key is turned to
'on' the laser will emit a brief flash but not fully power up. I am uploading
a video which will illustrate this property further..
The LD is mounted in a custom 2 piece copper mount. The focus assembly
also acts as an additional heatsink with deep fins.
Driver is a 3 mode featuring low, strobe and high.. There is no memory with this
and the laser starts in high. A brief interruption of power allows selection to low
power and the other modes by a slight tap on the clicky while in the 'on' position.
Battery used is 1 x 18650 unprotected (not included) though I am including
a new pair of goggles..
All thermal connections are made with plenty of acrtic silver paste and bonded
areas with arctic silver epoxy.
When the focus is set to a parallel beam, the focus ring sits tight against the
copper.. There is nothing lose fitting on this laser..
Asking 399. CDN shipped within North America with tracking. International
buyers are welcome, but will be required to pay for FedEx shipping as there is
no tracking available via Canada Post to overseas locations.
Warranty covers everything included and is good for 2 years from the purchase date..
Here are some pics, and video.
*EDIT* Low power pulsed is 200mW Med. power / strobe is 500mW
and high no pulse (CW) is 1.3W.
Last edited:
