- Joined
- Feb 11, 2013
- Messages
- 43
- Points
- 0
Could you PM me details on how much it would cost for only the attachment and shipping to Finland would cost?
Dan
Dan
@Pman
Blord was using 6V (four AA's) and the Arduino wouldn't run on that voltage in, so I told him to snip the Vin pin which makes it so the 6V wont go to the Arduino.
This way the 6V would any be powering the analog to digital converter, the Arduino would only be powered when it's connected to USB.
It's only necessary if using a 5.2V-6.5V source.
Thanks for the donation
Could you PM me details on how much it would cost for only the attachment and shipping to Finland would cost?
Dan
Just make sure the voltage doesn't exceed 10V (if Ophir version) as that's the maximum the Ophir rail splitter can take
The current draw is about 20mA IIRC, for the data logging board and Arduino.