Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

Check These Puppies Out!

Ehgemus

Ehgemus

0
Joined
Feb 28, 2009
Messages
1,384
Points
0
one is a red laser and the other is a blu-ray.
 

Attachments

  • 102_0804.jpg
    102_0804.jpg
    71.8 KB · Views: 440
  • 102_0805.jpg
    102_0805.jpg
    69 KB · Views: 407
  • 102_0806.jpg
    102_0806.jpg
    66.9 KB · Views: 408
  • 102_0807.jpg
    102_0807.jpg
    66.6 KB · Views: 412





Check these Puppies Out!

What's the specs ?!--Size, mW, duty cycle, burner, what type of hosts etc!!!--
They look pretty good!
 
Last edited:
Yes I made the heat sinks. The red host is the phr blu-ray running at 110mA. The black host is the red laser, not sure what the diode is but it is an open can diode. It is running at 150mA. Both are using the rkc driver and using two cr123 batteries. The host came from home depot. Thay are cheap but very nice.
 
Liking the heatsinks, nice job! (good photo's as well)

Regards rog8811
 
Man, these hosts are just popping up everywhere! Those look quite nice!! Love the heatsinks, they look like you could run an 8X or an LPC at 100% duty..

Just my opinion here, but if you were to modify your design to use a flexdrive and the original battery holder, you could probably fit those heatsinks almost entirely inside the head.
 
Last edited:
yes I'm going to make some to use the original 3xAAA battery holder and use the flexdrive.

Also thanks for the complements.
 
Those heatsinks make good use of the hosts... i have one of those flashlights, but never bothered to use it as a laser host since it would require a custom machined holder for the laser unit.

Your results look very nice!
 
Benm said:
Those heatsinks make good use of the hosts... i have one of those flashlights, but never bothered to use it as a laser host since it would require a custom machined holder for the laser unit.

Your results look very nice!
Click to expand...
Thanks, I can make you a heat sink if you like.
 
Benm said:
Those heatsinks make good use of the hosts... i have one of those flashlights, but never bothered to use it as a laser host since it would require a custom machined holder for the laser unit.

Your results look very nice!
Click to expand...


These hosts are identical to the "pocket pal" hosts, so the build can also be done the same way. When I saw these hosts for the first time, I took the guts out of one of my pocket pals and put it directly in that host. It fits perfectly. Since then I've built several more using the pocket pal build. If you have any pocket pal heatsinks around, you could use them..
 
You must log in or register to reply here.


Back
Top