Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

I didnt believe it, till I saw it. Submerged PC.

Joined
Aug 20, 2008
Messages
709
Points
0
Water isn't really conductive either; it's usually the ions dissolved in the water that cause conductivity.
 
Last edited:





Joined
Jan 2, 2009
Messages
11,800
Points
0
No kidding? I did not know that. I think I missed that in science class. I was always taught wet things, and electricity did not mix well.
 
Joined
Aug 31, 2009
Messages
2,157
Points
0
No kidding? I did not know that. I think I missed that in science class. I was always taught wet things, and electricity did not mix well.

That's because they didn't teach you that in school... I had no idea either. From what I just looked up its the minerals in water. They said pure or distilled water isn't conductive. Why didn't they just use that instead?
 
Joined
Aug 20, 2008
Messages
709
Points
0
No kidding? I did not know that. I think I missed that in science class. I was always taught wet things, and electricity did not mix well.

Technically, pure water is still slightly conductive; however, it's small enough to be negligible.

They said pure or distilled water isn't conductive. Why didn't they just use that instead?

I think it's because water has a tendency to cause corrosion (rust, oxidation, etc). This in turn could lead to ions in the water and conductance. Also, microorganisms like to grow in water unless you keep it filtered or disinfected...
 
Last edited:
Joined
Aug 31, 2009
Messages
2,157
Points
0
The fridge would be air tight. No condensation. Refrigerators these days dehumidify

EDIT: Yeah the pure water would be a bad idea then. I didn't think of that
 
Joined
Nov 11, 2009
Messages
331
Points
18
Wierd I thought condensation only formed on things cooler than the ambient temperature...

Your are right, but what if you had the CPU under load and it went up in temp. When it cooled back down would the air around it condensate? :thinking:

EDIT: I just read that post about fridges being air tight.

PS: But if you had to repair/remove some hardware, then it would condensate.
 
Last edited:
Joined
Aug 31, 2009
Messages
2,157
Points
0
You just let the fridge warm up if you need to change hardware... being a small fridge it wouldn't take long

EDIT: Or you could let the computer run while the fridge is off as well to heat it up to normal temp.
 

Asherz

0
Joined
Jan 18, 2009
Messages
1,623
Points
0
There's a few of these builds on youtube, they're cool but messy and you wouldn't be able to move your parts back into a normal case without a lot of cleaning.
 

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
Technically, pure water is still slightly conductive; however, it's small enough to be negligible.

That depends on the application, but it IS correct.

Both the concept that water is a good conductor, and the concept that it is no conductor at all, are false. One issue is that all liquids (and solids) show conduction to some extent, but pure water is still orders of mangnitude more conductive than mineral oil.

The 2 H2O <--> H3O+ / OH- equilibirium is responsible for this.

Don't go submerge electronics in ultrapure water though. Conducitivy from the above mechanism might allow it, but if it is contact with air, water will quickly absorb CO2 from the air, dropping the pH to 5-6 or so, and increasing conductivity wildly due to dissolved H3O+ and carbonate.
 

KiLLrB

0
Joined
Jan 27, 2010
Messages
1,072
Points
48
That depends on the application, but it IS correct.

Both the concept that water is a good conductor, and the concept that it is no conductor at all, are false. One issue is that all liquids (and solids) show conduction to some extent, but pure water is still orders of mangnitude more conductive than mineral oil.

The 2 H2O <--> H3O+ / OH- equilibirium is responsible for this.

Don't go submerge electronics in ultrapure water though. Conducitivy from the above mechanism might allow it, but if it is contact with air, water will quickly absorb CO2 from the air, dropping the pH to 5-6 or so, and increasing conductivity wildly due to dissolved H3O+ and carbonate.


Hmmm I learned something today lol. I hope for everyones sake nobody is actually considering submerging a computer in water. I really dont see it happening but you never know.
 
Joined
Jan 2, 2009
Messages
11,800
Points
0
Hmmm I learned something today lol. I hope for everyones sake nobody is actually considering submerging a computer in water. I really dont see it happening but you never know.

It would make one hell of a unique computer. I'm sure with some thick Plexiglas you could make a much more manageable case. Throw a few pulsing green LEDs in there, and you'd have a case straight from the movie Alien.
 




Top