You can easily take the module out of the L-C030, just screw the head off (Theres two sections, if you unscrew it and its just the driver hanging out then theres another sections just at the driver that should screw off) After you take it out just try running the lens with a micro-fibre cloth.
There are a few things that can give that pattern on DPSS. One of them is if crazyglue was used to install an IR filter, 2nd, which was already mentioned is mode switching. As the laser breaks in, the output beam from the crystals can change its exiting position, and when this happens the beam exits the crystal ex. to the left of the expander. Where before it was centered and now its hitting a drop of epoxy on the optics, or an imperfection on the expanding lens. It can also be the crystal set which also happens for no reason at all. I have encountered similar annomalies in my greenie builds, several hours of use after the build
If you dont want to damage your lenses during cleaning, this is the material I use, but can be hard to find, g00d luck!
Try cleaning the inside of the lens. My lens had a small, longish dust particle on the lens-side that was inside the module, and it was glued in!!Gave a similar pattern like yours.
Try cleaning the inside of the lens. My lens had a small, longish dust particle on the lens-side that was inside the module, and it was glued in!!Gave a similar pattern like yours.