rkcstr
0
- Joined
- Dec 1, 2007
- Messages
- 1,368
- Points
- 0
Re: Micro-Drive laser driver – fits Aixiz module
??
I'm sorry, I didn't see any messages from you in my PMs, and I don't delete any of them. I also don't remember reading any emails about what you're talking about.
Anyway, from what I've read in your posts, I suggest you do more research on what you need before you order anything. Why do you need a new driver for the green anyway? I've never heard of them going bad
Also, these will NOT run off of the same battery voltage as the original green driver, which is ~3V. I'm not sure what voltage the IR diodes in the greens are, but you'll need at least 2.25V over that to drive them with these drivers.
phoenix77 said:Hi rkcstr, This is phoenix77. I've sent you several PM's & at least 1 Email about my order, but haven't gotten a reply from you at all. I know you must be terribly busy, but my name isn't even on the latest post on customer order sequence. In case NONE of my other messages got through, I will re-place my order again here. Could you please build me 2(two) 150mW driver boards? My Email address is:fusedpulse@yahoo.com With shipping costs (to Indiana) the total cost should be $12.00, is this correct? Please send me an Email or PM to let me know that my order has been received & will be processed OK? Thank you so much, I can't wait to get my hands on them, they look like tiny works of art! THANKS/phoenix77
??
I'm sorry, I didn't see any messages from you in my PMs, and I don't delete any of them. I also don't remember reading any emails about what you're talking about.
Anyway, from what I've read in your posts, I suggest you do more research on what you need before you order anything. Why do you need a new driver for the green anyway? I've never heard of them going bad
Also, these will NOT run off of the same battery voltage as the original green driver, which is ~3V. I'm not sure what voltage the IR diodes in the greens are, but you'll need at least 2.25V over that to drive them with these drivers.