FS: WF-602c kit.

[Mohrenberg]

Kit comes with the host, heat sink, and a CR123 battery.

You will still need to buy a flex drive and a diode inside a module to finish this build.

Looking for $25 + shipping.
Click here to Purchase


You can also purchase the heat sink only for $10 + shipping.
Click here to buy a heat sink

 

[tommii89]

Could a red be built into this?

 

[bennett326]

yes why not?

 

[Mohrenberg]

yes. It just requires a boost driver like the flex drive since it only uses 1 battery.

 

[tommii89]

Sweet moh, pm details for 1 heatsink please

 

[Mohrenberg]

you just click the link above. Payal will take care of it

 

[tommii89]

Before I do, what do I need to do to make this a red build? I have diode and flex drive.. But don't know the steps, break it down for me? Just quikly

 

[bennett326]

um just set your current and your good what diode do you have?

 

[tommii89]

I have an lpc-815 and I have a ggw connected to the flex drive, I'll pull it off the ggw and run it at 390ma? I get that part. How do I wire the drive to the host is my real question as I'm not 100% what wires go where

 

[bennett326]

well the pill should have a contact board

 

[tommii89]

Right so just positive to the middle and negative on the rim? Is that right?

 

[bennett326]

yep pretty much

 

[tommii89]

OK - if ym flexdrive is currently set to GGWma, how do i raise it to 390ma?

Thanks

 

[bennett326]

i assume you have a dmm, but i doubt you have a testload?

EDIT: im going to sleep pm me and ill answer in the morning

 

[RA_pierce]

Mohrenberg - Payment sent for one kit. Thanks!

 

[Blord]

Do you know if these sinks are compatible with the C3 host ?