Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers



FS: WF-602c kit.

Mohrenberg

Well-known member
Joined
Aug 30, 2008
Messages
6,915
Points
83
Kit comes with the host, heat sink, and a CR123 battery.

You will still need to buy a flex drive and a diode inside a module to finish this build.

Looking for $25 + shipping.
Click here to Purchase


You can also purchase the heat sink only for $10 + shipping.
Click here to buy a heat sink

attachment.php
 

Attachments

  • wf602cc.jpg
    wf602cc.jpg
    45.9 KB · Views: 477
Last edited:



Mohrenberg

Well-known member
Joined
Aug 30, 2008
Messages
6,915
Points
83
yes. It just requires a boost driver like the flex drive since it only uses 1 battery.
 

Mohrenberg

Well-known member
Joined
Aug 30, 2008
Messages
6,915
Points
83
you just click the link above. Payal will take care of it
 

tommii89

New member
Joined
Sep 4, 2009
Messages
581
Points
0
Before I do, what do I need to do to make this a red build? I have diode and flex drive.. But don't know the steps, break it down for me? Just quikly
 

bennett326

Well-known member
Joined
May 10, 2011
Messages
1,908
Points
48
um just set your current and your good what diode do you have?
 

tommii89

New member
Joined
Sep 4, 2009
Messages
581
Points
0
I have an lpc-815 and I have a ggw connected to the flex drive, I'll pull it off the ggw and run it at 390ma? I get that part. How do I wire the drive to the host is my real question as I'm not 100% what wires go where :(
 

tommii89

New member
Joined
Sep 4, 2009
Messages
581
Points
0
Right so just positive to the middle and negative on the rim? Is that right?
 

tommii89

New member
Joined
Sep 4, 2009
Messages
581
Points
0
OK - if ym flexdrive is currently set to GGWma, how do i raise it to 390ma?

Thanks
 

bennett326

Well-known member
Joined
May 10, 2011
Messages
1,908
Points
48
i assume you have a dmm, but i doubt you have a testload?

EDIT: im going to sleep pm me and ill answer in the morning
 
Last edited:

Blord

New member
Joined
Dec 24, 2007
Messages
5,357
Points
0
Do you know if these sinks are compatible with the C3 host ?
 
Last edited:




Top