Custom Copper heatsinks made to order

[Flaminpyro]

umm ill have a think about it, many thanks

bumpup....

 

[Flaminpyro]

:bumpit:

 

[primary]

can you make a Cu sink with one side directly fitting the diode (phr/GGW) and one side threaded for aixiz lens?

 

[potatorage]

Can you make a labby style heatsink to fit the aixiz? Or maybe a 9mm diode?

 

[bobhaha]

can you make one to fit a rayfoss host? how much would that cost?

Thanks -Adrian

 

[Flaminpyro]

Yes...

can you make a Cu sink with one side directly fitting the diode (phr/GGW) and one side threaded for aixiz lens?

@ potatorage Yes...

@bobhaha most likely can you give me some diamentions, and we will go from there...

 

[primary]

how much would a copper sink that fits an aixiz module and into this host: [URL="http://www.dealextreme.com/details.dx/sku.26122"[/URL]
cost?

can i have you order the host and have you send the host+sink?

 

[Flaminpyro]

Howdy that heatsink would be $30.00 and yes I can order the host for you and ship the host with the fitted heatsink.

Best Regards Pyro... :eg:

how much would a copper sink that fits an aixiz module and into this host:
cost?

can i have you order the host and have you send the host+sink?

 

[potatorage]

Howdy that heatsink would be $30.00 and yes I can order the host for you and ship the host with the fitted heatsink.

Best Regards Pyro... :eg:

Hm, can you do fins as well? How much for say... a 1in x 1in x 2in block?

 

[Flaminpyro]

a solid block 1" x1" x 2" made from Cu would cost you $35.00+ shipping...

Hm, can you do fins as well? How much for say... a 1in x 1in x 2in block?

 

[potatorage]

How much do you think that would weigh?

 

[Flaminpyro]

1/4 pound at most...

How much do you think that would weigh?

 

[Flaminpyro]

1/4 pound at most...

:bumpit:

 

[Flaminpyro]

:bumpit:

:bumpit:

 

[Mohrenberg]

free bump!
i also wanted to let everyone know this is an amazing deal, I had spoke with my machinist who gives me VERY good prices on all my heatsinks, and the price it was going to cost to have copper sinks made almost made me crap my pants (seriously, it was bad).

apparently machining copper is very difficult because it's so soft, so if your wanting a copper heatsink you should jump right on this.

 

[scopeguy20]

As a very happy and proud owner of two lasers with these Copper h.s.'s in them, I can say the workmanship is flawless! Thanks Flamingpyro, these are the best heatsinked lasers I own! Also, a steal at $30 a piece IMHO! -Glenn