Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Custom Copper heatsinks made to order






Joined
Apr 6, 2009
Messages
281
Points
0
can you make a Cu sink with one side directly fitting the diode (phr/GGW) and one side threaded for aixiz lens?
 
Joined
May 31, 2009
Messages
3,239
Points
63
can you make one to fit a rayfoss host? how much would that cost?

Thanks -Adrian
 
Joined
May 4, 2009
Messages
5,443
Points
113
Yes...

can you make a Cu sink with one side directly fitting the diode (phr/GGW) and one side threaded for aixiz lens?

@ potatorage Yes...

@bobhaha most likely can you give me some diamentions, and we will go from there...
 
Last edited:
Joined
Apr 6, 2009
Messages
281
Points
0
how much would a copper sink that fits an aixiz module and into this host: [URL="http://www.dealextreme.com/details.dx/sku.26122"[/URL]
cost?

can i have you order the host and have you send the host+sink?
 
Last edited by a moderator:
Joined
May 4, 2009
Messages
5,443
Points
113
Howdy that heatsink would be $30.00 and yes I can order the host for you and ship the host with the fitted heatsink.

Best Regards Pyro... :eg:

how much would a copper sink that fits an aixiz module and into this host:
cost?

can i have you order the host and have you send the host+sink?
 
Last edited by a moderator:
Joined
Mar 20, 2008
Messages
1,341
Points
0
Howdy that heatsink would be $30.00 and yes I can order the host for you and ship the host with the fitted heatsink.

Best Regards Pyro... :eg:

Hm, can you do fins as well? How much for say... a 1in x 1in x 2in block?
 
Joined
Aug 30, 2008
Messages
6,891
Points
83
free bump!
i also wanted to let everyone know this is an amazing deal, I had spoke with my machinist who gives me VERY good prices on all my heatsinks, and the price it was going to cost to have copper sinks made almost made me crap my pants (seriously, it was bad).

apparently machining copper is very difficult because it's so soft, so if your wanting a copper heatsink you should jump right on this.
 
Joined
Jun 28, 2007
Messages
3,443
Points
63
As a very happy and proud owner of two lasers with these Copper h.s.'s in them, I can say the workmanship is flawless! Thanks Flamingpyro, these are the best heatsinked lasers I own! Also, a steal at $30 a piece IMHO! :) -Glenn
 
Last edited:




Top