Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

20% off! Mohgasm.com

Status
Not open for further replies.
yeah i was all excited when i got one at a garage sale for $10, and then found out they were already cheap and i didn't really get that much of a deal....
However i also picked up a 20" LCD monitor for $2 that they thought was broken. I replaced a bad cap and i'm using it right now.....so jokes on them.
 
Last edited:





I just tried to order some stuff, but I'm not sure if it went through? how would I know?
 
Did you receive a confirmation email? If so, it went through. How did you pay? Paypal or credit card?
 
I didn't get a confirmation email yet, how long should it take to get it? I paid with PayPal.
 
Check your Paypal account in 30 minutes. If it isn't there then you probably did it wrong.
 
OK, I guess I didn't do something right the first time. I ordered it again and and this time it was successful.

Thank you sooo much Matthew for the great deals and products at Mohgasm!
 
Hey moh, do the krytons in your shop come with anodizing removed or must that be done on the customer's end?
 
Mohrenberg said:
Check your order. You didn't specify an output for like 11 of the driers
Click to expand...

I was thinking that I could leave the current settings blank and you would include some resistors so that I could add them myself. Can you still do that?
Probably should have said that in the order.
 
With the Krypton you can pick from 5.6mm or 9mm. I haven't really planned what diode I'd like to put in this host, what would you recommend? A couple of diodes that I've seen are 3.8mm, does that mean I can't put them in this host?
 
I would go ahead and get the 5.6mm ones. Mrcrouse can drill it out for a fee and press in a 3.8mm module if you so desire. Only one readily available 9mm diode though.
 
Yeah there are only heads for 5.6mm, and 9mm diodes.
If you want to use a 3.8mm diode, you need someone to drill out the center of the head to 12mm, and add a set screw so that you can put a module in it.
 
Mrcrouse is opening them up and press fitting 3.8 modules because a set screw won't look right.
 
Status
Not open for further replies.


Back
Top