- Joined
- Dec 15, 2014
- Messages
- 6,773
- Points
- 113
Hi Everyone,
Found tis host ,nice small side clicky, so i modded the driver as a contact board with the screw in pill. Also hand fitted the CU washer to take up the slack for the sink to ground to the pill.
Inside is ::
1) NDB7875/9MM Diode.. Took off the lens that was on it. Not a G9 to DTR's observation sorry folks oops!! Thank You Jordan
2) X Drive set to 2.4A Bridged for second range.
3) G2 Lens
4) 2-18350 Efest Cells
I have the lens soaking in Acetone to loosen the glue for prepping into a lens barrel. Will compare later with the G2 and 3 element.
Enjoy folks..
Rich
Found tis host ,nice small side clicky, so i modded the driver as a contact board with the screw in pill. Also hand fitted the CU washer to take up the slack for the sink to ground to the pill.
Inside is ::
1) NDB7875/9MM Diode.. Took off the lens that was on it. Not a G9 to DTR's observation sorry folks oops!! Thank You Jordan

2) X Drive set to 2.4A Bridged for second range.
3) G2 Lens
4) 2-18350 Efest Cells
I have the lens soaking in Acetone to loosen the glue for prepping into a lens barrel. Will compare later with the G2 and 3 element.
Enjoy folks..
Rich

Attachments
Last edited: