In the GGW sled, there is a "finned" heat sink that should be facing "up" in the upper right hand of the picture above. The picture shows the finned part to the right "side" of the sled (facing sideward) but not the one that should be facing "up."
4X sleds look identical to this sled WITHOUT the finned heat sink.
We may want to hold off until we get a few of these tested.
If they are the 4X sleds, they will be good for about 150mW.
Dave post the 6x sled of the finned heatsink if you can. I have looked and had no luck yet.
If this is the case at least I could ask them, in an unpleasant way to change the description on the site :gun: this should be a sign to them that they aren't going to get away w/ that petty crapola. I will wait of course to receive them just to verify
they are not 6x's. What else could I do?.
Here is a pic from Drews site of the 6x it is obvious of the finns in the bottom left hand corner the pic from rayfross dosen't have them
still will have to wait for the units to arrive before I put the hammer to them for false advertise the start a thread then
<me taking a deep breath>.
BINGO! No need for me to find a picture of a 6X sled. You have one here. The 6X heat sink is visible in that pic. The heat sink is atached to the sled with a small phillips head screw and some thermal "putty." The 4X sled is identical but without that extra heat sink.