Kenom
0
- Joined
- May 4, 2007
- Messages
- 5,628
- Points
- 63
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Kenom said:No lazors? that's not a good thing. I don't know for sure that the krytons will be to you by the time that it gets to ya. The reason for laser as a requirement is so taht you won't be tempted to play with the calibration lasers for anything other than testing. So you might want to consider your participation in this. Not saying you can't unless you aint got lazorz.
Ok I've got my two setup and they are lasing. I'm looking at how long folks are wanting to test these things for average? 30 seconds? 1 minute? Only reason I ask is I'm lookin for stability. The bluray has been set to 102mw but after a minute it does increase a mw or 2. Seems to keep increasing as well. I'm doing some testing on stability
jayrob said:Maybe just a little digital thermometer to include in the kit to record room temperature? Then just write down other conditions in our test notes...
Jay
Kenom said:I have one of those cheap IR thermometers that tests whatever you point it at. I can sure ship it along.
Kenom said:ok she's ready to ship off with the exception of one thing. I ended up cutting into the wire below the heatshrink tubing so I'm going to replace the heatshrink tubing. I'll also include the thermometer. The lens has been glued into place with some thermal silicone It's easily removed but such that you can see if it's been tampered with. The head is GORILLA glued into place. It'll come apart but it will take a LOT of work. I set both focuses at about 6" so anything beyond that the focus will be off.
I will ship this off to pseudo tomorrow. Then let the testing begin