- Joined
- Aug 10, 2008
- Messages
- 268
- Points
- 18
i am selling one of my kryton groove lasers. it is polished and has a PHR-803T diode and a groove driver set at 120mA. it uses 2x CR123 (16340) or 1x 18650. this laser burns really nice, and i am letting it go cheap to fund my next laser project a 30K scanner.
:anyone:
I am asking $80.00 for this laser + S&H (usually less than $5.00)
here are the pix...
the heatshrink on the tail switch spring is to isolate the spring from the spacer (separate case from battery GND) and the wire on the groove driver is flying leads to the diode, since the diode is recessed into the head.
:drool:
:anyone:
I am asking $80.00 for this laser + S&H (usually less than $5.00)
here are the pix...
the heatshrink on the tail switch spring is to isolate the spring from the spacer (separate case from battery GND) and the wire on the groove driver is flying leads to the diode, since the diode is recessed into the head.
:drool: