- Joined
- May 14, 2008
- Messages
- 468
- Points
- 0
....
Otherwise, do you need the raw PIV data for your compilation?
YES!:yh:
....
Otherwise, do you need the raw PIV data for your compilation?
A very nice diode indeed! 414mW's at 290mA's (405-G-1) is sweet! And I noticed that the forward voltage is low too! Compared to Dave's diode, which is up around 6 volts at that current...
Yes, i was wondering about that! I was asking myself "Where the hell is the voltage everyone is talking about?!?" :thinking:
... Jay: You have one at almost the same current and power, right? Do you perhaps know it's Vf?
I didn't write it down, but I know it was not 6 volts. 5.7 rings a bell...
Dr. Lava had posted that he would recommend only 6 volts, which is about 300mA's on some of the BDR-203 diodes...
But I know of at least one person running a FlexDrive in a Pocket Mini/8X at 360mA's.
I wonder what would happen if the voltage that the diode was wanting could not be delivered by the driver? Would is just not give anymore power than a certain point, or would the driver shut down?
At any case, I would imagine that Dr. Lava gave a fairly conservative recommendation...
Can't wait to see those greens Igor.
Igor:
In spite of the fact that I cannot understand where, in a 24 hours day, you'll find the time to do also this:bowdown:, I am enthusiast of this decision!
I'm sure that the Spartans I tried from DL failed due to an insufficient driver design....