Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

Building Tiny DDL Driver

I'll leave jib to help you. He understand better than me :p
I was with my email open so I answered fast. I'm going to sleep soon. ;)

good luck with the driver dude, build me one :p
 





Jib... you're really going to hate me soon - I think you should be charging me tuition ;)

Do you know of an IC that fits the following specs:

- LDO (like an LM1117)
- 1.5A or higher current
- Normal LM317 pinout
- Is Negative regulating?

It occurred to me that my upcoming C-Mount build will require a case (+) design. On the bright side, that diode is only ~2.2V, so I can get away with a singe li-ion build, as long as I have an LDO regulator :) Was going to go LM337, but they have an LM317's voltage drop (I believe)
 
From my understanding you don't want to use a neg-reg if your source voltage is positive. Is the case pin not isolated from LD+? The only thing I can think of is using one of those 3A transistors as a Current Sink driver, but I don't know too much about those.
 
With my C-Mount diode, there actually isn't a case pin, the case itself is the LD+. There would be no way whatsoever to isolate it from the case.

My case must be positive.

So neg-regs don't just regulate the (-) rail instead of the (+) ?
 
rhd said:
With my C-Mount diode, there actually isn't a case pin, the case itself is the LD+. There would be no way whatsoever to isolate it from the case.

My case must be positive.

So neg-regs don't just regulate the (-) rail instead of the (+) ?
Click to expand...

Nope, they actually output negative voltages with -1.25V the closest you can get to GND without biasing the Adj pin w/ +1.25V.

Check out the datasheet for the LM337 from OnSemi: http://www.onsemi.com/pub/Collateral/LM337-D.PDF
 
So, regulating the (-) line from the battery at -5V relative to ground, if ground was the case (+) feed from the battery.

^

That's not the same thing as regulating the (+) from the battery to +5V relative to ground, if ground is the (-) feed from the battery?

If not - don't worry about an explanation - I'll take your word for it and go do my own research. I'll need to come up with a new approach though, because I have no choice but to do a case-positive build.
 
rhd said:
So, regulating the (-) line from the battery at -5V relative to ground, if ground was the case (+) feed from the battery.

^

That's not the same thing as regulating the (+) from the battery to +5V relative to ground, if ground is the (-) feed from the battery?

If not - don't worry about an explanation - I'll take your word for it and go do my own research. I'll need to come up with a new approach though, because I have no choice but to do a case-positive build.
Click to expand...

I think you may be right, as this system is not connected to earth ground. Its more about electron flow than potential in relation to earth ground.
 
You must log in or register to reply here.


Back
Top