WTB - Flexmod P3 Or similar driver

[Deleted member 49011]

Hi

Dose anyone have any flexmod P3 drivers for sale or similar , I'm looking for at least three with a current of 4A +

Thanks

 

[94Z28]

contact me for some modulated 8A with PWM or external pot

 

[ElectricPlasma]

X-wossee on eBay has some nice ones: 8A Modulated Buck Laser Diode Driver with Thermal Protection NUBM08E Etc | eBay

 

[diachi]

X-wossee on eBay has some nice ones: 8A Modulated Buck Laser Diode Driver with Thermal Protection NUBM08E Etc | eBay

That not the same driver 94Z28 is talking about?

Might check out OptLasers too - polish based, good products as far as I've seen.

eBay: http://www.ebay.com/sch/optlasers-com/m.html?_nkw=&_armrs=1&_ipg=&_from=

Website: http://optlasers.com/en/

 

[Deleted member 49011]

contact me for some modulated 8A with PWM or external pot

Thanks but ive found some flexmods available , if I need something more ill give you a PM ,

Can your drivers be run in parallel reliably ?

That not the same driver 94Z28 is talking about?

Might check out OptLasers too - polish based, good products as far as I've seen.

eBay: optlasers-com | eBay

Website: Opt Lasers

Thanks , Ive looked there but I need 11.5A / 4V Drop and three flexmods P3 are a cheaper option once I add in tax / shipping .

 

[diachi]

Thanks , Ive looked there but I need 11.5A / 4V Drop and three flexmods P3 are a cheaper option once I add in tax / shipping .

Fair enough!

Got a cool project that you're going to be sharing with us soon?

 

[Deleted member 49011]

Fair enough!

Got a cool project that you're going to be sharing with us soon?

Maybe : P , Its just to test a 20W 915nm Fibre coupled laser diode , its a bare fiber type like the 7W 940nm one had a while back and I ran that with two flexmods P3 drivers

this one needs 11.5A @ 4V Max

 

[Alaskan]

I would like to know how well the flex mods work and whether isolation diodes are needed.

 

[Deleted member 49011]

I never ran two Flexmods P3 in parallel with isolation diodes , I just run them with everything in parallel and used a 5V single from a potentiometer .

Never did any high speed modulation and I didn't have any problems running them like it so I will just do the same with three each set to 3.35A