Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

my first build check my plan¡¡¡¡

I believe they make a protected and unprotected version. I was incorrect about the batteries that I measured today, they are unprotected 18350s.:oops:

Protected batteries are longer than normal ones because they have a circuit board attached to the top. Since the unprotected ones are 1-2mm longer, protected ones will be even longer, so they may not fit after all, but I don't have any to measure.
 
Last edited:





Dogs Best Friend said:
I believe they make a protected and unprotected version. I was incorrect about the batteries that I measured today, they are unprotected 18350s.:oops:

Protected batteries are longer than normal ones because they have a circuit board attached to the top. Since the unprotected ones are 1-2mm longer, protected ones will be even longer, so they may not fit after all, but I don't have any to measure.
Click to expand...

so i need cr123 protected cells????

there are aw cr123 it can be good???
 
nice i already order the (presale) JAD kit from Moh, it will be arrive between april 22 and 23 :D :D :D :D :D :D :D :D :D :D :D
 
Good!
You can use rcr123 (16340) http://www.lighthound.com/AW-IMR163...LiMN-Rechargeable-Lithium-Battery_p_2626.html or the AW 18350s, http://www.lighthound.com/AW-IMR-18350-700mAh-LiMN-Rechargeable-Lithium-Battery_p_3818.html they will both fit for sure.
I don't know if protected 18350s will fit, since they are longer than normal ones.
Protected batteries are not essential. Unprotected batteries are able to run until the voltage gets so low, the batteries are damaged, protected cells prevent that. So you can run unprotected batteries with no problem if you pay attention to run time and voltage.
 
Last edited:
His kits are awesome, you won't be disappointed. A little advise, when screwing the heatsink down. Make sure the heatsink doesn't twist while your turning the lid. If the heatsink starts twisting you are also twisting your wires attached to the diode. Don't want that to happen... Good luck, let us know how it goes.
 
TacoHerder said:
His kits are awesome, you won't be disappointed. A little advise, when screwing the heatsink down. Make sure the heatsink doesn't twist while your turning the lid. If the heatsink starts twisting you are also twisting your wires attached to the diode. Don't want that to happen... Good luck, let us know how it goes.
Click to expand...

ok man i will post the results in other thread when it will be completed

thanks for the tip :p
 
marianin said:
thanks for the tip man but it doesnt matter i already order a JAD kit from Moh,
Click to expand...

no problem, I just didn't want you to pay that much for what it's really worth :beer:

good luck with your build !
 
Last edited:
foulmist said:
no problem, I just didn't want you to pay that much for what it's really worth :beer:

good luck with your build !
Click to expand...

thanks i will post the laser in other thread wen it will be finished and i am planning a violet laser :)
 
You must log in or register to reply here.


Back
Top