lazeerer
0
- Joined
- May 25, 2010
- Messages
- 3,655
- Points
- 0
Re: My 445nm Build with the 18650 Aurora SS R2 Cree From Jayrob!!! "Picture Heavy"
More "Heavy Pic's" With some new updates.
In these Pic's i made heatsink for my flexdrive V5. I had a scrape piece of aluminum rod and just cut a 1/4 inch piece off for a heatsink. I used arctic silver adhesive on the the 2 chips on the bottom side of the V5 to transfer heat better to the heatsink, then just raped a piece of electrical wire around it to hold it in place just in case something shifts inside. Also i do plain on turning this up even more.
Just a couple more Cool Pic's of the Beam.
:thanks: For Looking.....
More "Heavy Pic's" With some new updates.
In these Pic's i made heatsink for my flexdrive V5. I had a scrape piece of aluminum rod and just cut a 1/4 inch piece off for a heatsink. I used arctic silver adhesive on the the 2 chips on the bottom side of the V5 to transfer heat better to the heatsink, then just raped a piece of electrical wire around it to hold it in place just in case something shifts inside. Also i do plain on turning this up even more.
Just a couple more Cool Pic's of the Beam.
:thanks: For Looking.....
Last edited: