micro boost question

[Machro]

can i change the current setting from a micro boost drive ?

 

[Ignis Fatuus]

The Photonlexicon.com forum can help on most of your questions. You should check them out too. Signing up is easy.

When asked, you should know that LASER is an acronym consisting of the following constituent words:
Light Amplification by Stimulated Emission of Radiation

Dr.Lava, who invented the microboost hangs out over there more than here.

 

[drlava]

haha, Ig what are you trying to do!!

Here machro, the manual that talks about range setting is here, the answer is yes.
the manual is on this page:
MicroBoost Drive

 

[IsaacT]

Just to make sure (pardon my threadjack), I bought a Microboost and selected a preset current, I don't have to set ANYTHING right? It is set up already?

 

[DTR]

The Photonlexicon.com forum can help on most of your questions. You should check them out too. Signing up is easy.

Man you are cruel.:evil:

Just to make sure (pardon my threadjack), I bought a Microboost and selected a preset current, I don't have to set ANYTHING right? It is set up already?

You will have to solder the four leads but other than that it will be good to go.:beer:

 

[Kevlar]

Just to make sure (pardon my threadjack), I bought a Microboost and selected a preset current, I don't have to set ANYTHING right? It is set up already?

If you ordered one with a pre-set current then it should be good. It is always a good idea to hook it up to a dummy load and check it. The tiny pots on these can be sensitive and could have been jolted in the mail. Chances are it is fine but I always like to make sure.

 

[IsaacT]

Alright thanks guys, for the great information. /me hands back OP's thread :beer: