- Joined
- Oct 26, 2007
- Messages
- 5,438
- Points
- 83
I apologize cilgegray. I didn't see your correction in the later posts.
Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers
Buy Site Supporter Role (remove some ads) | LPF Donations
Links below open in new window
FrozenGate by Avery
Measuring current with dmm?
- Thread starter borgqueenx
- Start date
I apologize cilgegray. I didn't see your correction in the later posts.
- Joined
- Jan 8, 2009
- Messages
- 3,144
- Points
- 83
If I remember right most all DMM have a back-up fuse in the back of it, take it apart and check it.
For the most part I think the language barrier messed this all up.
For the most part I think the language barrier messed this all up.
Thanks much
- Joined
- Dec 29, 2009
- Messages
- 3,136
- Points
- 63
measuring current in series?
1: Put black in com and red in the 10A
2: turn dial to 10A
3: put meter into the circuit loop
4: turn circuit on.
5: measurement is in Amps. 1000mA = 1A
6: turn circuit off.
7: remove meter and turn it off.
8: Important: to avoid shorting something out on accident next time you use the meter, ALWAYS move the red back to its proper plug. It should only be in the 10A plug temporarily while you measure current.
To measure at <250mA, you must make sure the fuse is intact, and you don't have to mess with the 10A plug, you can just leave the red lead in its normal plug.
1: Put black in com and red in the 10A
2: turn dial to 10A
3: put meter into the circuit loop
4: turn circuit on.
5: measurement is in Amps. 1000mA = 1A
6: turn circuit off.
7: remove meter and turn it off.
8: Important: to avoid shorting something out on accident next time you use the meter, ALWAYS move the red back to its proper plug. It should only be in the 10A plug temporarily while you measure current.
To measure at <250mA, you must make sure the fuse is intact, and you don't have to mess with the 10A plug, you can just leave the red lead in its normal plug.