FusionDrives GB - CLOSED

[busterhax]

to bluefusion: SenKat is not assembling anymore drivers, i paid you for an assembled driver. any way i can get some type of compensation?

also, any instructions as to how to assemble these?

 

[pwnstar]

to bluefusion: SenKat is not assembling anymore drivers, i paid you for an assembled driver. any way i can get some type of compensation?

compensation of what? 2$???
anyways, mine arrived today.
Thanks so much senkat.  

Edit:
Instructions for people too lazy to do a simple search for them
http://hacylon.case.edu/laser/Fusion_Drive_assembly_instructions.pdf

Edit:
(after seeing those nice pics I feel mean! lol nice job)

 

[busterhax]

here is my first completed driver. what a pain!

it fits 100% perfect into the sonar case from wicked. too bad i have no diodes to test it out

 

[Dark_Horse]

Received mine today, Thanks Greg! ;D

 

[Kenom]

Assembly really isn't that hard. here is a picture of a fusion next to the newer groove driver

 

[Kenom]

and here.

 

[positron]

That groove driver looks great

 

[Dark_Horse]

Does anyone know what the "ohm-range" is for the little "pots" in these kits?
DH

 

[Kenom]

1K OHM pot.

 

[nein166]

I got my drivers Thank You so much SenKat

I was checking the board and found 2 holes that stand alone and don't connect to anything.
Its the same on all three boards the other two are still in an uncut form, I've illustrated in a picture
(Yes I cut the board down to fit in a Minimag tube, I'm from CPF)

I have a picture in my photobucket and will post it after I rack up 10 posts

The board is very different from the original blueprint so I can't figure where resistors 100k and 2.7k need to be connected.
I think I should bridge them both to the figure-8 shaped pad coming from R1
Again there is infinite resistance between these pads and any other point on all three of my boards

Any advise would be greatly appreciated.

 

[Kenom]

What is your username on CPF?

 

[nein166]

What is your username on CPF?

Its the same nein166

 

[nein166]

heres the photo

 

[Kenom]

Well, you can post the link to photobucket and I'll fix the link for ya. Just put a space inbetween www photobucket com and i'll post the fix. I've put that instruction manual together so will be able to help ya out. you can also look at the picture I posted a few posts back and see how I've put them together. they are pretty detailed pictures.

 

[Kenom]

Ok now that you can post that picture. Your driver won't work. You cut one of the traces needed to go from the neg to r4. I don't see any way to salvage that other than making your own wire trace on the bottom side. However the two indicated resistors are in the correct place. Actually it can even be swapped around as you will select one or the other but only 1 for high or low range.

 

[nein166]

Right I should have posted the backside as well the neg path goes to R4 on the back and then on to C1 and then to diode ground pad.
So I think I understand that if I connect the 100K resistor to the pad as illustrated by the blue line for Bluray range 12-75ma I should be alright