Richie89
0
- Joined
- May 9, 2015
- Messages
- 1,181
- Points
- 113
This was the laser I bought from Jordan over 4 months ago and never got around to building it because of the break up. I finally decided to do it! I am also using the High power driver from Gary and it works great! He set it to 3.8 amps which should be good for about 5 Watts due to this Diode hitting 5.6 on a G2 at 3.8 amps so I’m thinking at least 5, unfortunately my meter only goes to 2 so testing it is out of the question. I have never thermally glued a driver to a heat sink and I was hoping I did it right. This G ball has absolutely horrible divergance but hey what can you expect from a powerful MM Diode. I can say I didn’t like how the wiring came out because I cut the wires too long and they’re crammed in there pretty good, plus I had to use electrical tape cause my shrink tube wasn’t big enough for these wires. All in all I think it turned out okay