501b/ Custom Sink and Knob NUMB 44 SOLD !!

[Lifetime17]

Hi,
Just had to do it, had a 44 diode for a while i set it to 2.8A /X Drive/G2 lens. Cut pocket with brass ring for contact board pressed in, with two solder tabs.ran this for 1min 30sec. just a little warm, very little. Cool small host with a lot of sinking.Takes 2-18350's
Here are some pics
Rich :sold::thanks:

 

[BobMc]

Re: 501b/ Custom Sink and Knob NUMB 44

Hi,
Just had to do it, had a 44 diode for a while i set it to 2.8A /X Drive/G2 lens. Cut pocket with brass ring for contact board pressed in, with two solder tabs.ran this for 1min 30sec. just a little warm, very little. Cool small host with a lot of sinking.Takes 2-18350's
Here are some pics
Rich

Nice build! Bet with that large heat sink that 044 will like its new home!

 

[Lifetime17]

Re: 501b/ Custom Sink and Knob NUMB 44

Hi BM,
Thanks it really doesn't get warm after 90 seconds, the sinks do there job well .I might pull the diode and driver and put it in a larger host and put it up for sale, undecided . i posted two other sale threads but the Mods didn't approve them since yesterday

Rich

 

[Comander Shepard]

Re: 501b/ Custom Sink and Knob NUMB 44

That is a nice build. How long does it take to cool down?

 

[Lifetime17]

Re: 501b/ Custom Sink and Knob NUMB 44

HI CS,
Not long at all because it doesn't get that warm to start with , and the mass os the sink is effective

rich