Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Custom Copper heatsinks made to order






Joined
Mar 10, 2009
Messages
115
Points
18
In copper that would be $37.50 and that would include a machined Aixiz module fitted to the heatsink.
Pyro...
how much would it be without the Aixiz module? I'm using a sure module, and i could send you that with the host. It won't be for a little while, as i need to get the funds together.
 
Joined
May 4, 2009
Messages
5,443
Points
113
If you send the sure module with the host then I can machine fit both pieces to the heatsink. that would be $24.00
I won't be back till after xmas so the time frame works out !
Pyro...


how much would it be without the Aixiz module? I'm using a sure module, and i could send you that with the host. It won't be for a little while, as i need to get the funds together.
 
Joined
Mar 10, 2009
Messages
115
Points
18
How much would shipping be for a coleman max cr2 heatsink? and it is $25 for the heatsink and rib reduction on it, am i correct?
 
Joined
May 4, 2009
Messages
5,443
Points
113
Shipping is only $3.00 for a coleman max CR-2 and heatsink. and that would include the rib removal from the host.

Pyro...


How much would shipping be for a coleman max cr2 heatsink? and it is $25 for the heatsink and rib reduction on it, am i correct?
 
Joined
May 4, 2009
Messages
5,443
Points
113
Dont be sorry ! it's not an old thread ;)
Yes I'm taking orders for custom copper heatsinks for use with Aixiz modules or "direct Press" for either 3.7mm, 5.6mm or 9mm diodes.
Please contact me via PM, Thanks !
Pyro...



hey, are you still making these? sorry if im just bringing up an old thread.
 
Joined
Oct 28, 2007
Messages
2,631
Points
48
How much would a block, base being 40mm x 20mm ; and 40mm high cost? I would need it to fit an aixis module with set screw on top of the assembly. I would also need small fins on the sides, but it is essential that the dimensions stay at 40x20x40, so the fins would just cut into the block itself, not protrude out. The bottom needs to be flat, and I don't need any holes drilled into it anymore.

I would need this mainly for testing diodes.

Thanks a ton in advance,

Amk

COMPLETE EDIT: Changed the idea as a whole.
 
Last edited:




Top