Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers



Wire Glue? Any one ever tried it.

I know some of the Eghemus hosts. You can bend the pill a little for an oval shape. It will hold by the host much better.
 





img0247sm.jpg


Here you go. The cutouts in the pill are for a dual ben boost to fit on a press fitted copper coin. When you screw in the direct press sink it should make contact but that's not the case with normal glue.

greetings,,

EDIT: A lineair or buck driver or buck driver would of been much easier to build in terms of room in the pill but i decided to make it a imr 18650 build to make it interesting for myself :)
 
Last edited:
A little dent won't make a big difference but the pill will hold onto the host.
Or just glue a small section and leave a bigger area free for electrical contact.
 
Blord said:
A little dent won't make a big difference but the pill will hold onto the host.
Or just glue a small section and leave a bigger area free for electrical contact.
Click to expand...

I might try that :) Check if that works and still is strong enough to withstand the battery throw in and out :tinfoil:
 
Try spraying the surface with WD40, then scraping it to reveal the bare, non-oxidized aluminum which can be soldered to through the layer of WD40. (source)
 
Bionic-Badger said:
Try spraying the surface with WD40, then scraping it to reveal the bare, non-oxidized aluminum which can be soldered to through the layer of WD40. (source)
Click to expand...

So if i understand correct i slightly sand the alluminium, spray WD40(the blue yellow spray bottle) onto it and then i am able to solder the pill to the heatsink?

Is that a strond bond?
 
Last edited:
You must log in or register to reply here.
Back
Top