iskor12
0
- Joined
- Jan 23, 2009
- Messages
- 2,113
- Points
- 0
I no longer have that second light. It should be clearly obvious if it is two boards or not. If it is just one board...then that's ok...but you are going to have to de-solder everything on it so that it is bare.
Then you are going to have to find where the positive and negative connections are on both sides of the board.....(Continuity check is the easiest way to find out)
Then continue on with the instructions normally.
Then you are going to have to find where the positive and negative connections are on both sides of the board.....(Continuity check is the easiest way to find out)
Then continue on with the instructions normally.