DWells55
0
- Joined
- Jun 16, 2008
- Messages
- 53
- Points
- 0
So I recently got all my parts for my Blu-Ray build and extracting the diode from the DVD drive took five minutes and went without a hitch. However, I've been working with the diode itself and the AixiZ module for over an hour now and absolutely cannot get it to sit flush. Here's a picture:
It's not the best picture, but you should be able to see that the side of the diode facing the camera is angled upwards. I absolutely cannot get it flush no matter how I try to press the thing together. I tried styropyro's method of using the other half of the housing to press it in, but all that did after a while was dent the housing.
Any ideas? Will it still work properly angled like that?
It's not the best picture, but you should be able to see that the side of the diode facing the camera is angled upwards. I absolutely cannot get it flush no matter how I try to press the thing together. I tried styropyro's method of using the other half of the housing to press it in, but all that did after a while was dent the housing.
Any ideas? Will it still work properly angled like that?