Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

Survival Laser DIY Host Assembly Photo Tutorial (Picture Heavy)

LORDJET said:
Hey Garoq, I was wondering if you can use a single 18650 battery with your set up?
Click to expand...

You can, but the laser output will only be 150-200mW. On the positive side, it's like having a two-mode laser!
 





Interesting, I wonder if you could use two of those drivers in parallel with a 2W Nichia diode to increase the output? Hmm, not sure what kind of driver it is though.
 
PersonGuyDude said:
Interesting, I wonder if you could use two of those drivers in parallel with a 2W Nichia diode to increase the output? Hmm, not sure what kind of driver it is though.
Click to expand...

I assume you are talking about the A140 diode which can produce a maximum of about 2 watts laser output using 1.8A current without seriously jeopardizing reliability. Two of these drivers would produce 2.5A, which is too much power for these diodes.
 
Last edited:
Ah ya, that's true. Is the driver for the survival laser kit linear or boost?

-Thanks for answering my questions :)
 
Its a linear driver, thats how you can have 2 power "modes" via 2x cr123a vs 1x 18650. Would be nice to have a boost driver but its a simple buck driver, works great for what it is. I have a few lying around waiting for time and money to go into a project.
 
woohooo! i just finished my kit Garoq and it is perfect! burns like a beast and I love it, very easy build and the tutorial helps every step of the way, to everybody if you want to make your first build this is a very nice, easy setup with a wonderful tutorial. thank you very much again Survival Lasers! i will be buying many more products from you if you make other kits and DIY lasers!

thanks!
 
jakeGT said:
woohooo! i just finished my kit Garoq and it is perfect! burns like a beast and I love it, very easy build and the tutorial helps every step of the way, to everybody if you want to make your first build this is a very nice, easy setup with a wonderful tutorial. thank you very much again Survival Lasers! i will be buying many more products from you if you make other kits and DIY lasers!

thanks!
Click to expand...

Thanks Jake! :beer:
 
The DIY kit doesn't come with the battery contact board/circuit board in the pill, you have to purchase it separately. Will the circuit still be complete if you just press the circuit board into the brass ring or do you have to solder the brass ring to somewhere on the board? Also doesn't include heatsink, but thats no problem.
Thanks
 
Laik said:
The DIY kit doesn't come with the battery contact board/circuit board in the pill, you have to purchase it separately. Will the circuit still be complete if you just press the circuit board into the brass ring or do you have to solder the brass ring to somewhere on the board? Also doesn't include heatsink, but thats no problem.
Thanks
Click to expand...

What DIY kit are you talking about? The one described in this tutorial comes with a heat sink and a preinstalled driver.
 
You are looking at the host only. It comes with the pill and brass ring but no circuit board. Those can be purchased separately.
 
Oh ok, i assume you had to buy the heat sink to? Just your personal opinion, how do you think a purple heat sink with a normal focusing ring and a phr 803t diode would look?
 
You must log in or register to reply here.





Back
Top