Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

Searching 2 small leds.

borgqueenx

borgqueenx

0
Joined
Jun 30, 2008
Messages
1,660
Points
48
Im searching for a orange and red led. I ask you because i have zeto experience with the leds.
I want one thats already wires and connectors on them.(~20cm wire)And then the brightest you got.

Edit: and i forgot: they dont need to require a heatsink.
 
Last edited:





I have some LED's. What are the diameter of the LED you need ?
 
Errr well the current leds are glued behind the holes.
So i need them to shine forwards and not emit their light all around if possible.
 
Lucky for you I just have red, orange and blue LEDs. They are clear and shine forwards.

Oranje 2000mcd 5mm LED
- Nominal current: 20 mA
- Voltage: 1,70-1,90V DC
- Light power: 2000mcd
- Light colour: Yellow 580nm-585nm
- Light angle: +/- 15 deg


Red 5000mcd 5mm LEDs
- Nominal current: 20 mA
- Voltage: 1,70-1,90V DC
- Light power: 5000mcd
- Light colour: Red 620nm-625nm
- Light angle: +/- 15 deg

PM me your address and I sent you a few.
 
Well if it helps any, check out uniqueleds.com. I buy all my stuff from them. Fast shipping, I do live just south of them though. They have a decent selection and all their leds are cheap. Priced how leds should be.
 
You need to tell us what you're trying to do. The fact that you're asking for a 5V LED tells me you have no idea what you're doing.
 
3mm%20red%20led%20diffuse%20tinted.jpg


+

resistor.jpg


+

Dayga-T2-16_Gauge_Brown_2_Conductor_Speaker_Wire_100_Ft.jpg


+

4004H-4006H.jpg


=

501.jpg


Note: LED's do not magically multiply.
 
Last edited:
Its a good thing else jerry would have zero rep by now for every bitch post he makes.
Things: im lazy :D but if there is no other option i will do that.
I want them to go on when the laser goes on. The pt-itrust has a led ouput pins located for that and outputs 5v...
 
Last edited:
In case you didn't know. Led's are current driving devices. There is not such thing as 5V leds. You probably measure the driver in an open circuit, hence 5 volt.
If the driver is properly build then it will output 20mA at ~1.7-1.9V.
 
Oh...on ebay i found different voltage leds.
Yeah i just used the dmm to measure what voltage was set on the pins.
So i guess i should be searching in that range for leds?:)
 
Why don't you take my LED's ? I haven't talk about money. That means they are FREE !! :D
 
Well I was really referring to giving Cyparagon some +rep, because his statement above is spot on.
 
You must log in or register to reply here.


Back
Top