FOR SALE 155.00 + Shipping
Hi, Here is a PL520B in a 501B host custom heat sink with deep fins for cooling, Flex Drive V5 set to 275mW/ G2 lens.
It takes 1X18650 battery LPM is at 130mW's. This is a single mode diode.
Thank You Rich
I have just about the exact same green 501b big brother to this from Rich going on 3 years. Only green I bring out for pointing these days. It loves the cold weather..
Tring, I got a Christmas surprise 505nm Gift from Lifetime17 Rich could of clear powder coated the copper like the black coated AL host but I sprayed clear enamel on the sink and it's held up well, the pic show's going on 2 weeks
Hey Rich, I need a couple of adaptor plates for my new beam expander, I will drill and tap them myself but I don't have a lathe to turn down the pedestal, so I need a 1/2 inch long length of 2.5 inch wide round aluminum bar stock 1/2 inch long turned down to 30mm at 0.25 inch depth.
Here's a drawing, I could not get it to upload in a message for some reason. This will attach to 2.5 inch wide heat sinks that I drill for modules myself and/or a combined & corrected builds front plate, the adaptor plate will have 3 screw holes on the outer perimeter along with set screws adjacent to the attachment screw holes so I can adjust the angular alignment, but I will drill and tap myself, I just need the pedestal turned down.
Note: the 12mm hole is just for the beam to pass through, my module will be mounted in my heat sink that this adaptor plate will attach to, so no set screw needed and no need to rush.
Hi LPF, FOR Sale.... 220.00 + shipping
Ok just finished a ML562G85/9mm/638nm/ G2lens/Twin Beam build. It has a massive AL sink with a CU core. I used a Black Buck 3 driver set to 2.4A, sinked with a large CU sink I did on the mill. It holds 2X32650's or 2X26650's The AL sink is over 300Grams my scale won't go any further so it weighs more than 300G. Wired with 22 AWG Sillycon wire Well here are some pics enjoy.