Pro Tips w/ Spyderz20x6: Building your first DIY Laser!

[AUTO XX]

Yeah but negative and funny are usually the same thing :crackup:
I just got done my first 445 handheld with the new lathe. Gotta grab the camera and show you how I did it. Pretty easy just a little fiddly to solder the caps inline. 1.6 watts baby!!!

 

[Tech_Junkie]

Some people like me, some don't. I'm not here to persuade people either way. I'm me, and thats all I can be.

 

[jkardon1992]

I'm building a 405nm. It said that they are not case ground.

1. what does this mean
2. why does it matter.
3. how do i connect the pin to the unused pin, i thought i snap the unused pin off.

 

[Tech_Junkie]

Read the first link in my sig, then this link.

http://laserpointerforums.com/f42/meta-topic-pinout-performance-actual-ld-26417.html

 

[Ali051292]

hi. im new in this page. and it is my first time to build my own homemade burning laser. i got one lpc-815 250-300mw laser diode, one amc7135 350ma drive, one coated glass lens for red laser 635nm-980nm and one aixix module or 5.6mm laser dioedes, but i dont really know how to connect my laser diode to my amc7135 driver. can i use the 350ma to my laser diode 250-300mw?
thank you for help

 

[Flaminpyro]

This is an old thread to be asking this in but I guess it will work.

To answer your question, YES if your amc7135 driver only puts out 350ma that should not be too much for
a LPC-815 laser diode as long as it's in an Aixiz module or a better direct press heat sink.

Here is a picture of a amc7135 350ma output, can some one look at it and tell him which pair L or R is the input and output.
http://www.dealextreme.com/customerphotos/3160-633d0981-a44b-48d0-9c35-59e8bb147782.jpg

Good luck...

hi. im new in this page. and it is my first time to build my own homemade burning laser. i got one lpc-815 250-300mw laser diode, one amc7135 350ma drive, one coated glass lens for red laser 635nm-980nm and one aixix module or 5.6mm laser dioedes, but i dont really know how to connect my laser diode to my amc7135 driver. can i use the 350ma to my laser diode 250-300mw?
thank you for help

 

[lasersbee]

That guy is SPAMMING the same question all over
the Forum....:tsk:


Jerry

You can contact us at any time on our Website: J.BAUER Electronics