Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

PLTB450B/1.6A X Drive/G2 Copper sink and Knob

Lifetime17

Lifetime17

0
Joined
Dec 15, 2014
Messages
6,773
Points
113
Hi Folks,

Just wanted to share this build with you. Its a 2-14500 cell / PLTB450B diode / X Drive set to 1.6A/ G2 lens. Its a Mini Mag knock off in Silver.. Full copper heat sink and Knob. Tested for 2 min. only warm to the touch, copper is amazing for sinking as we all know. Enjoy !!

Rich:)
 

Attachments

  • IMG_2494.JPG
    IMG_2494.JPG
    153.1 KB · Views: 90
  • IMG_2495.JPG
    IMG_2495.JPG
    211.4 KB · Views: 106
  • IMG_2496.JPG
    IMG_2496.JPG
    236.1 KB · Views: 89
  • IMG_2493.JPG
    IMG_2493.JPG
    199.8 KB · Views: 93
  • IMG_2497.JPG
    IMG_2497.JPG
    169.2 KB · Views: 103
  • IMG_2498.JPG
    IMG_2498.JPG
    154 KB · Views: 101
  • IMG_2499.JPG
    IMG_2499.JPG
    130.9 KB · Views: 94





Another beauty from lifetime! With that copper sink, man , I bet that could almost run till the batteries went dead. Lookin good��
 
Hi BM,
I actually ran this for about close to two min. and i only was warm. Yes the copper is amazing for sinking and Aluminum isn't bad for a long duty cycle either. As long as there is enough mass your good to go Buddy..
Thanks again Pal Rich:)
 
You must log in or register to reply here.


Back
Top