Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

new host?

Thanks man! :) i Like Blord's green one a lot. The one thing is, could i put diode with a momentary switch into this?
 





No problem. I don't think you can do a momentary switch with the Cree C-6 host unfortunately. It uses a tail end switch. You might be able to do it if you drill a hole into the side of the host to fit the switch through. Hope I could help.
 
Hey where did you get the green laser in the small pen host? if thats a CNI laser you must be VERY careful trying to get the module out of the original host!!! Did you get it from Dragonlasers?
 
Last edited:
Blord said:
Not possible, the new host is too short. There is just not enough space to accommodate the green module, driver and the battery.

You can try the Aurora C6 host. It has a longer head.
Click to expand...

On the contrary. It just takes some creativity.

I managed to stuff a 532 in a 1xAAA MXDL host after all.

100_0746.JPG
 
Hey where did you get the green laser in the small pen host? if thats a CNI laser you must be VERY careful trying to get the module out of the original host!!! Did you get it from Dragonlasers?
Click to expand...

No, its from Pickegg.com, which doesnt sell anything above 5mW anymore. mine is a 50mW
 
@Abean95: Ahh i see okay lol
I didnt even know they ever sold pointers

@ qumefox: Did you pull the module from a pen just like Abean95 has in hand or did you start with a module?


Abean95 said:
No, its from Pickegg.com, which doesnt sell anything above 5mW anymore. mine is a 50mW
Click to expand...
 
Last edited:
Started with a module, but it really doesn't matter, the 'bare modules' are the same thing you'll find in pens, right down to the drivers with the push buttons.
 
You could make that work in the cree c6 host if you want. Just drill a hole in the side (if you can) and then either just leave the tail switch clicked on or you can bypass it completely. For ease of assembly I would just leave the tail switch clicked on and drill the hole for the switch.
 
You could make that work in the cree c6 host if you want. Just drill a hole in the side (if you can) and then either just leave the tail switch clicked on or you can bypass it completely. For ease of assembly I would just leave the tail switch clicked on and drill the hole for the switch.
Click to expand...
Alright, i think i will try that. Thaks for the advice :)
Does DX ship fast?
 
You must log in or register to reply here.


Back
Top