- Joined
- Oct 10, 2008
- Messages
- 314
- Points
- 18
That's just about identical to the heatsink design I came up with for the L2P, so I would guess that the two hosts have the same interior...
My heatsink also has a smaller section at the bottom that fits into the battery compartment to make the heatsink longer yet. This was needed for an 18650 to fit properly.
I will have a cavity for the driver, and it will be fit for a contact board with brass ring to press in the bottom of the cavity...
Not a press fit design. But fit for an AixiZ module with a set screw. For a press fit design, the press area would be way up inside because it would need to be close to the lens. (same distance as an AixiZ module)
That sounds like a winner! How much would cost to have one made?