Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

FS: Coleman Hosts for sale + heatsink

Peng said:
Hello Mohrenberg,
Payment sent for one kit.
Let me know if you will be sending the other item at the same time.
Thanks,
Peng
Click to expand...

yes, i was thinking i would just put your other item inside the kit ;)
 





hey moh, if i get the host and heat sink, do i only need to get a module from o-like and put it in the heatsink? (is that how you make your green builds?)

if its that easy, i'll take one, and can i get a few 3.0V duracells with it for $30 shipped?
 
sure can, i ship flat rate priority for intl so i'll chuck in a good sized bag of them......around 15-20 batteries
 
yeah, the green modules seem to be about the same length as an aixiz module and cr2 battery combined, so it fits great to use a green module and 1 CR2 battery
 
I'll take one if possible

And any tips for where is the best place to find the Juiced 3.6V CR2 batteries or a charger for cheapest? Mine from the phr build have just emptied
 
Last edited:
alright, i'll get yours outtomorrow with the others....better check and see if peng would like some cr2's incase hes making a green laser.
 
great, now i just need to drop susie a payment :D
btw, just out of curiosity, what was the laserbee reading on the 110mA phr ?
 
i already have these about as low as i can go (consider these flashlights are $26.88 at wal-mart new, plus a custom machined heatsink, these "should" be worth atleast $40)

primary said:
great, now i just need to drop susie a payment :D
btw, just out of curiosity, what was the laserbee reading on the 110mA phr ?
Click to expand...

don't recall if it was 110mA, yours which i refunded was outputting 119mW


i think the phr i tested with closed and open back at 110mA was 85mW closed and 106mW open (not entirely sure on the first number...can't really remember)
 
robjdixon said:
Just a quick question - do these flashlights use a "pill" or do I solder a spring onto the rckstr driver?
Rob
Click to expand...

the way i make them, you have the rckstr driver enclosed inside the aixiz module, the module being case negative, with the pos. wire coming out of the end, I put some epoxy on the end of the aixid module with a little plastic o-ring spacer, then strip the pos wire coming out of the end, curl it up flat against the spacer and solder it, so you have a positive contact point on the end of the module.

there is a spring on the tailcap switch to keep things tight.

LOC are already case negative, for phr, you just bend the case pin on the diode down and solder it to the negative pin.
 
Mohrenberg said:
the way i make them, you have the rckstr driver enclosed inside the aixiz module, the module being case negative, with the pos. wire coming out of the end, I put some epoxy on the end of the aixid module with a little plastic o-ring spacer, then strip the pos wire coming out of the end, curl it up flat against the spacer and solder it, so you have a positive contact point on the end of the module.

there is a spring on the tailcap switch to keep things tight.

LOC are already case negative, for phr, you just bend the case pin on the diode down and solder it to the negative pin.
Click to expand...

Cool. Do you have a spare o-ring spacer that you could send?
 
You must log in or register to reply here.


Back
Top