Three weeks ago I ordered four Flexmod P3s from a member of PL. I haven't gotten a response yet and my project is on hold. The specs. on the P3 are perfect and I will need 10-12 of them. Are there any choices for sources for this driver or are there any other alternatives to the P3 with similar specs.
LPF Donation via Stripe | LPF Donation - Other Methods
Links below open in new window
ArcticMyst Security by Avery
Flexmod P3
- Thread starter planters
- Start date
I'm not sure if it has the exact same capabilities, but have you looked into the "Die4Driver"?
It has modulation, but I'm not sure if it will boost voltage.
Hmm okay it only allows for 2A.
http://www.die4laser.com/dvd-rec/Die4Drive.htm
I think they can be bought ready assembled somewhere.
It has modulation, but I'm not sure if it will boost voltage.
Hmm okay it only allows for 2A.
http://www.die4laser.com/dvd-rec/Die4Drive.htm
I think they can be bought ready assembled somewhere.
Last edited:
- Joined
- Jul 4, 2008
- Messages
- 2,499
- Points
- 113
Die4driver (v1.3) is NOT a boost driver. You'll need 7.4v for a 445nm diode.
7.4vdc delivers 4.6vdc to diode.
- Joined
- Oct 26, 2007
- Messages
- 5,438
- Points
- 83
The Flexmod isn't a boost driver either. You need Vdiode + 1.5V to power the thing.
I am less interested in a boost function as in the Flexmod's high voltage capability. I am going to run several 445 diodes in series so 4.2Vx3 +1.5V is OK. These diodes can handle 1.5A and this is the other feature I need. I am using these diodes in a projector and the analog modulation is important also.
