moonreft
0
- Joined
- Sep 1, 2009
- Messages
- 108
- Points
- 0
The learning curve is a bit more then I thought. Then again theory and practice can be two different beasts. I had built my first dummy load and then stepped down the volts with another small board. I set it at just under 400mA for the LC diode and soldered on my main leads. I did one last test before hooking up the LD and it smoked and flashed. Looks like the solder bleed through a bit too much.
Anyone know a better way to drop voltage btw? Daisy chaining 1n00* diodes takes up a bit much room.
Anyone know a better way to drop voltage btw? Daisy chaining 1n00* diodes takes up a bit much room.