DTR
0
- Joined
- Jun 24, 2010
- Messages
- 5,680
- Points
- 113
Re: 445 1-2W Blue Diodes *Tested* $45 Shipped US $40 each additional in same order.
Yes you can bridg the case pin and the negative on the NJG but remember to connect the bridged negative and case pin with the driver negative output. This will also lock the unit into always on full power mode all the time. So no modes. And the answer on the spring is yes as well. The spring can be used to make direct contact with the positive of the battery.:beer:
Just got home from my Easter outings. I will put one together here in a little and give you some readings @ different voltages of the minimum mA.
I have an aurora cree c6 flashlight. I've tried to find data sheets on this driver but haven't been able to find any so I'm just going off a few pictures. OK, so if I use this NJG-18 driver how do I wire it up correctly? Does the sping on the NJG-18 go to the positive side of the battery? Can my host be negative? Do I join the case and negative pins? I'm pretty much trying to draw a diagram on how to wire it.
Yes you can bridg the case pin and the negative on the NJG but remember to connect the bridged negative and case pin with the driver negative output. This will also lock the unit into always on full power mode all the time. So no modes. And the answer on the spring is yes as well. The spring can be used to make direct contact with the positive of the battery.:beer:
P.S. I am still waiting on your tests...
Just got home from my Easter outings. I will put one together here in a little and give you some readings @ different voltages of the minimum mA.
Last edited: