Jstr
0
- Joined
- Feb 10, 2014
- Messages
- 347
- Points
- 0
So I am planning on building a pair of m140 diodes into a couple relatively small hosts. I found this DX driver (actually 2, which is an added bonus).
I also like the current, at 1400 mA because it won't push the heatsink's capacity too much . I'm not sure about the 5 modes, if the 10% one will even work, but other than that it seems like a good deal. Probably the biggest reason I like it is that it runs off just one lithium ion battery.
I am still a little skeptical, however, so I thought I'd run it by some laser pros first good idea or no?
I also like the current, at 1400 mA because it won't push the heatsink's capacity too much . I'm not sure about the 5 modes, if the 10% one will even work, but other than that it seems like a good deal. Probably the biggest reason I like it is that it runs off just one lithium ion battery.
I am still a little skeptical, however, so I thought I'd run it by some laser pros first good idea or no?