Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

¿to have 500mw or 1w of red 635nm ttl point?

ppbss

0
Joined
Aug 22, 2010
Messages
56
Points
8
Hello necessit one red 635nm 500mw or 1w, for projector RGB, advise...?
 
Last edited:





I need that 4x4mm does not have much divergence less, if is but great it leaves the galvos, as it shows the images
 
u need to get a better translator mate, i cant understand a word your saying


He want someone to reccommend him a 500mW-1W 635nm module w/ TTL modulation.
He preferably wants it to have a 4x4mm beam with as low divergence as possible.
 
ok I'm looking at a better translator

ok GRIX thanks
 
Last edited:
You can try asking at photonlexicon.com . They know more about high powered lab modules.
 
yes , this is close to what I need, thanks
 
Last edited:
ASI MEJOR
Hello necessit one red 635nm 500mw or 1w, for projector RGB, advise...?
 
500mW or 1W laser diodes are expensive, at 635nm, and usually multimode (bad beam profile, without correction optics)

Have you considered the opportunity to use a 660nm unit, or DIY a setup/combiner ? ..... or is obligatory to use a 635nm unit ?
 
HIMNL9, if it can be like just a red module, so no I have to put 2 modules pbs, as seen 642 more could be enough to 400MW, kgb_productiones thanks, I'll look, I want the white is cold meccla I am thinking of 640nm or 642nm:can:
 





Back
Top