Pinout m101u29

[Kookapeli]

What is the pinout on this ? And is it case negative/posative/neutral ?

Thanks

 

[Nexgen]

They are case negative. It makes so many trouble putting them into host.
Right pin is positive.

 

[Kookapeli]

Do you have a diagram on which the right pin is, in which position the LD is ?

 

[Nexgen]

Like this:

 

[Kookapeli]

Like this:

That's the one

 

[paul1598419]

This is also the pinout for all the LPCs. Like the LPC816, 826, 836 840. I use the CG adjustable X-Drive from lazeerer. It is my favorite driver for case negative diodes.

 

[Kookapeli]

This is also the pinout for all the LPCs. Like the LPC816, 826, 836 840. I use the CG adjustable X-Drive from lazeerer. It is my favorite driver for case negative diodes.

Do you have a link ?

Tia

 

[paul1598419]

Sorry, I don't. As far as I know these drivers have been discontinued. I had a couple from about three years ago when I purchased several from Angelos. But, he is not making these any longer. That's too bad as it is a great driver. I have them in many of my builds. I even used one in an M140 build for vortish several years ago because it was going into a 501B host and I needed to limit the current to 1.5 amps.

 

[Kookapeli]

All the good drivers are sadly not available, the mohgasm drivers were good too

 

[paul1598419]

I should send Angelos an email and see if he responds. Who knows what he might have lurking in his stockpile. He must be still around as these X-Drives and SXD drivers are all his.