- Joined
- Sep 22, 2012
- Messages
- 228
- Points
- 28
First of all, apologies if this has already been covered in another thread.
I've made a few sinks in preparation for the arrival of a couple of modules.
I'm a bit unsure about the Pill/battery contact board part of it though and thought I'd better ask some experienced minds before I make a mess of things.
The pills I've used are out of various flashlights, but I haven't got any that are bare, so I tested one of them and it turned out that the output voltage was the same as was going in.
So here are my questions......
1. Should I check all of them before using? As I assume they would function differently.
2. Am I just being over cautious as the drivers on the modules will regulate power?
3. I think some of them control modes as in high/low/strobe etc, so should I just de-solder all the components making them nothing but a + - pathway to the drivers?
*pics added.
Thanks guys.
I've made a few sinks in preparation for the arrival of a couple of modules.
I'm a bit unsure about the Pill/battery contact board part of it though and thought I'd better ask some experienced minds before I make a mess of things.
The pills I've used are out of various flashlights, but I haven't got any that are bare, so I tested one of them and it turned out that the output voltage was the same as was going in.
So here are my questions......
1. Should I check all of them before using? As I assume they would function differently.
2. Am I just being over cautious as the drivers on the modules will regulate power?
3. I think some of them control modes as in high/low/strobe etc, so should I just de-solder all the components making them nothing but a + - pathway to the drivers?
*pics added.
Thanks guys.