- Joined
- Feb 9, 2008
- Messages
- 273
- Points
- 0
so i was testing my new microboost to use with a 445nm, and i had a test load of 4x 1n4001 diodes in series, and i was also measuring current. powered the driver with a power supply at 3.6v, with a 3A max. however, the max current i could get after turning the pot was 840mA and the min current was 360 mA. this isnt a range that drlava lists on the manual. maybe i soldered a little too much when jumping the resistors on the driver??? is the driver still safe to use? it did sit at a very constant current though when running the test load