WTB: cr2 charger

[Eudaimonium]

i have two, one is a uni from modwerx, the other(one mentioned) is a ultrafire WF-138 switching charger(charges both 3.0 and 3.6v) for CR123s. so i can use a small magnet to fill the space? that sounds like a good idea, thanks man.

It is perfectly OK to use magnets to fill space for CR2s , however only on CR123s and similar smaller capacity batteries (3V, not 3.7V)

Don't try something like that with 18650 charger that provides 1 A charging current, with smaller 16340 or 10440 batts.
Charging current must always be UNDER 1C of a battery.
CR2s are around 500-600mAh if I am not mistaking?

All of them say 800 but I think it is overrated greatly, I have a pair of those but not the charger, so I cannot test those.
I will most likely pick up a $7 charger+ 2pcs batts from O-like next time I order from them.
I have to test the capacity of those I have.

 

[kingdave2357]

My CR2s are now charging nicely in my CR123 charger! +1 for the advice, you saved me at least $5, and some waiting.
used the small magnets from a GGW sled!


EDIT: @OP, if you want that module end, PM me your shipping address so i can send it out

 

[jake royston]

I apprreciate all the help you have given me! i would have bought another charger or primary batts if i didnt know you could just use some small magnets!!! thanks!!

 

[Eudaimonium]

No problem folks, that is what this forum is for = helping each other out!

Enjoy!

 

[kingdave2357]

Jake, your aixiz module end was shipped out to you today! Enjoy, and good luck with your builds!:san:

 

[jake royston]

thanks!