Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

Wicked Lasers S3 Lunar Repair!!

Joined
Oct 6, 2015
Messages
1,524
Points
113
I purchased this Lunar and attempted to operate it. Although the unit was factory-sealed never used, the laser repeatedly shut down during operation. Additionally, the push-button control code was not functioning correctly.
I decided to disassemble the unit and perform a technical inspection. Upon examination, I discovered that the negative (ground) connection had been improperly soldered and was completely disconnected from the ground circuit, resulting in an open electrical connection.
I also determined that the microcontroller was factory-locked. After unlocking the chip ( Connecting a USB to the P13-P14-P1-P4 ), I was able to access and reprogram it with the correct operating mode. Further investigation revealed that the original firmware was generating a memory-related error, which was preventing the device from functioning properly. Please refer to the attached images for documentation of the hardware defect and subsequent corrections. 👽IMG_1472.JPEGIMG_1483.JPEGIMG_1484.JPEGIMG_1493.JPEGIMG_1494.JPEGIMG_1498.JPEGIMG_1502.JPEGIMG_1503.JPEGIMG_1505.JPEGIMG_1506.JPEG
 
Last edited:





I can only post 10 images, but I have many more documenting the entire teardown and programming process. The microcontroller is read-protected and hidden behind the three LEDs, so it’s not visible in the pictures.The cool part is that once unlocked, you can modify the C++ settings binary and add more options! It took me almost 2 days using hex editing and other techniques. This is extremely complicated and not something anyone should attempt! Reading it can return 0xFF and potentially erase the chip. I also made multiple binary backups because even saving an edited file can corrupt it. 🫥
 


Back
Top