- Joined
- Oct 6, 2015
- Messages
- 1,524
- Points
- 113
I purchased this Lunar and attempted to operate it. Although the unit was factory-sealed never used, the laser repeatedly shut down during operation. Additionally, the push-button control code was not functioning correctly.
I decided to disassemble the unit and perform a technical inspection. Upon examination, I discovered that the negative (ground) connection had been improperly soldered and was completely disconnected from the ground circuit, resulting in an open electrical connection.
I also determined that the microcontroller was factory-locked. After unlocking the chip ( Connecting a USB to the P13-P14-P1-P4 ), I was able to access and reprogram it with the correct operating mode. Further investigation revealed that the original firmware was generating a memory-related error, which was preventing the device from functioning properly. Please refer to the attached images for documentation of the hardware defect and subsequent corrections.










I decided to disassemble the unit and perform a technical inspection. Upon examination, I discovered that the negative (ground) connection had been improperly soldered and was completely disconnected from the ground circuit, resulting in an open electrical connection.
I also determined that the microcontroller was factory-locked. After unlocking the chip ( Connecting a USB to the P13-P14-P1-P4 ), I was able to access and reprogram it with the correct operating mode. Further investigation revealed that the original firmware was generating a memory-related error, which was preventing the device from functioning properly. Please refer to the attached images for documentation of the hardware defect and subsequent corrections.










Last edited:

