Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

VERY NEW! i need lot of infos! and help

thank you a lot this is a nice drawing...the heatsink on MXDL are the washers?? are they glued to stay in place?
 





are they glued to stay in place
Click to expand...

Personally, I would sand off the plating from the faces and the hole in the washers and from around the front part of the Aixiz module. Then solder them all together, that way you will get the best possible thermal contact. I have never used washers, with a bit of luck someone who has used them will answer that one for you ;)

Regards rog8811
 
if i commanded a pre-installed sony diode in aixiz module from stontek, do i need to undo it so i can solder the diode with the driver??? o.O?
i want to make my own driver too... and if i make the driver made by the guy from the tutorial, will it make a good laser? can i do something to have a stronger laser...?

ty for help, sorry i know i got lot of question.

Edit: so what do you suggest for heatsink?
 
You must log in or register to reply here.


Back
Top