LaZeRz
0
- Joined
- Feb 19, 2011
- Messages
- 2,549
- Points
- 63
Talk about it being hard to fit two lr123a batteries in....
I had to fit 2 PROTECTED cr123a cells into my hotlight..... I had to sand down the switch, trim the spring and make the switch sit over a cm below the bottom of the pill, so the batteries can fit and then i had to apply a solder blob to the connection point on the switch and grind the pill down to make room for a coin modded driver.......... now thats annoying!
I had to fit 2 PROTECTED cr123a cells into my hotlight..... I had to sand down the switch, trim the spring and make the switch sit over a cm below the bottom of the pill, so the batteries can fit and then i had to apply a solder blob to the connection point on the switch and grind the pill down to make room for a coin modded driver.......... now thats annoying!
